0

Left/Right for a single workout

Jeff Dell

April 08, 2015 19:35

None

Follow

Is the left/right currently working? It seems like the right was imported but the left was not, but both left/right workouts were downloaded and removed from the device. I wasn't sure if there is something that I need to do, or it is just not supported yet. Thanks!

• Facebook
• Twitter
• LinkedIn

7 comments

• 0
  
  Tim Clark April 09, 2015 00:29

  Hi Jeff -- are you using (2) runScribe -- one configured for left and one configured for right? Or are you trying to swap a single runScribe mid-workout? If the latter, that will be in a coming firmware update.

• 0
  
  Jeff Dell April 09, 2015 00:34

  I am using 2 runScribe's and both are on and blinking.. both had the exact same files when I finished the workout and I copied files from both runScribe's to the server after the workout. but on the server it only showed one.

• 0
  
  Tim Clark April 09, 2015 00:56

  Just looking at your runs -- and it seems like the RIGHT is there, but the file for the LEFT side is pretty funky.

  You might try :
  1 -- connect to the LEFT runScribe, go to the Info screen (swipe right to left to reveal) and verify that the F/W is either 6.08 or 6.09.
  2 -- go to the Config screen (left to right to reveal), scroll down, then do a 'Force Erase'. This will restore the file system to default state.
  3 -- do just a quick (like 2-3min run) to test end-to-end that it's working.

  NOTES :
  A -- we've had quality issues with the (included) Panasonic batteries, so you might have gotten a dud!
  B -- your Sensitivity setting is likely fine, as your RIGHT recorded fine, but it's sometimes possible that you'll need to adjust this UP.

• 0
  
  Jeff Dell April 09, 2015 01:00

  it is on 6.08 and I did force remove all files on both before I started... I did a force remove all files again. The battery level says 100% and it has no problem connecting. I will go for a run tomorrow and report back what I find. Thanks for the quick response.

• 0
  
  Tim Clark April 09, 2015 01:16

  Thanks Jeff!
  I also pushed 6.09 for update today -- if you're willing -- update your LEFT (you can do your RIGHT as well) to 6.09 -- as that gives me a little more debug info in the event that there is something wrong with your LEFT side.

• 0
  
  Jeff Dell April 09, 2015 02:14

  Updated to 6.09, removed files and ready for test tomorrow.

• 0
  
  Jeff Dell April 09, 2015 18:02

  To follow up... still no luck with left/right.